Because cement is the largest component of the siding it s hard on saw blades.
Patching hardboard siding.
Scoop a golf ball sized.
Slightly overlap the putty onto the surrounding hardboard by 1.
After installation you caulk and paint it like any other siding.
The fiber cement siding is nailed in place so the rows are consistent with the rest of the wall.
Use a 4 foot level to check and then hammer in another nail.
If water seeps into joints between hardboard panels or penetrates through small holes it will cause the panels to deteriorate.
How to repair masonite wood siding 1.
Step 2 apply filler compound.
Sand the area smooth and then paint it to match the rest of the siding.
1 scrape all loose paint from around the area to be repaired using a paint scraper or putty.
Scrub the brush around the hole to dislodge dirt and debris.
Step 1 check the siding panels and clean the holes.
How to repair hardboard siding.
Step 4 paint the siding.
How to repair masonite siding with putty step 1.
So if you re cutting much a masonry blade is a great idea.
Hammer down loose nails.
Now when somebody googles what i tried they 39 ll at least get my post and know they 39 re not the only one.
If you re replacing more than one board in a run simply hammer a nail into the top corner to support it and then move half way down the board.
Clean the hardboard with a stiff bristle brush.
Be sure the top one goes through both boards.
Scrape off flaking paint and debris from the damaged area using a paint scraper.
If the nails do not stay put hammer additional 2 inch nails beside the original nail to.
Then hammer away on the rest of the board.
Immediately fill holes with a flexible all purpose filler such as pre mixed bridging and patching compound following label directions.
The best filler for your siding is a two part epoxy product that cures to a rock hard consistency.
Step 3 sand the area.
When the new siding has been painted two coats of top quality acrylic latex over a primer the repair is hard to spot.
The siding panels nearest to the.
Check the siding panel for molds holes or any damage.
Pack wood putty into the hole using a trowel.
Level the wood.
